The proper cable increases your machine availability

The selection of the right cable or line for transmitting signals on your machine has essential influence on the machine availability. Usually, when determining the instruments of machines and plants, a profound level of attention is given to deciding on the best sensors.
For example, an individual determines which measuring principles are used for level measurement, which power should be provided to the machine and which kind of signal transmission should be used. Usually, the cables shown in the wiring schemes as simple connection lines between sensor and SPS are problematic. This poses a fascinating paradox in the automation technology ? Upbeat is tested for highest demands to assure it meets certain requirements of the application form, whereas a cable is merely seen as a component which supposedly guarantees a trusted connection under all circumstances.
However, cables and connectors pose just about the most frequent sources of error. This is often where unforeseen potential for increasing machine availability are available. During my span of research I learned that in a higher two-digit percentage of all cases, renowned cable manufacturers traced back sensor failure on machines to mechanical failure of the cable because of faulty installation, handling and especially because of the choice of an unsuited cable for the precise application. Principally, there is no patent fix for determining which cable and which plug connector is most beneficial suitable for the application.
For instance, flexibility demands for cables found in level probes for level measurement in deep wells aren?t high, whereas the demands on tensile strength together with high longitudinal and transverse water tightness are. In level probes, plug connectors are barely ever applied as a result of lack of permanent leak tightness. For machine tools which are create in factory buildings, the easiest cable materials with a straightforward M12 connector are employed. In cases like this, however, the usage of the right cable that permanently withstands ambient conditions such as temperature fluctuations and that features resistance against oils and fats can significantly raise the availability of your machine.
The usage of cable assemblies with factory pre-assembled connectors also prevents failure risk through improper on-site assembly. It is therefore a fallacy that all cables are the same and that any given cable with the sufficient number of wires is suitable for an application.
In one of my previous articles, I drew up a brief overview of probably the most relevant criteria for choosing cables and connectors. Take your time in specifying a suitable cable for your application. Think about the demands your plug connection to sensors and PLC must meet. An individually matched wiring concept offers a measurable increase of the device availability and higher safety during operation.
In the event you need assistance or consulting for specifying a suitable pressure sensor and associated cable / connector, feel absolve to contact us.

Leave a Comment